Page 2 of 2

Re: Grid blocking resistors explained

PostPosted: Fri Dec 22, 2006 10:23 am
by De Ferre
ricochet wrote:If you try something and it smokes, stop and back up a step.


Don't do that on a coffee-shop terrace in Amsterdam, next to those water-channels... :roll:

I used to connect two guitars at the same time to those inputs, though I just used one at a time, kept the other at volume zero. I hope I didn't do anything wrong, did I?

PostPosted: Fri Dec 22, 2006 4:54 pm
by jaybee
rustyslide wrote:You mean the electrons don't get confused!?! :shock:


not like us they don't :roll: :lol: :lol:

PostPosted: Fri Dec 22, 2006 6:18 pm
by ricochet
Those little suckers are always on the lookout for a shortcut.

easy schematic tips

PostPosted: Sat Dec 23, 2006 8:11 pm
by Splash
If you look at the input jacks in this schematic, you will see j1 (jack #1) goes thru R1 (resistor #1) and then it connects to the wire from J2 (input jack #2) that also goes thru a resistor r2. So, if you plug into J1 that signal can be picked off as it goes to the 1st stage of V1 (12AX7) of the preamp by plugging into J2. Follow the wires...

Image

PEACE
Scott
Believe in Magic!