Amp outlets

[Locked - post in relevant instrument/gig/recording section]

Re: Grid blocking resistors explained

Postby De Ferre » Fri Dec 22, 2006 10:23 am

ricochet wrote:If you try something and it smokes, stop and back up a step.


Don't do that on a coffee-shop terrace in Amsterdam, next to those water-channels... :roll:

I used to connect two guitars at the same time to those inputs, though I just used one at a time, kept the other at volume zero. I hope I didn't do anything wrong, did I?
User avatar
De Ferre
Regular
 
Posts: 172
Joined: Mon May 15, 2006 9:22 am
Location: Belgium

Postby jaybee » Fri Dec 22, 2006 4:54 pm

rustyslide wrote:You mean the electrons don't get confused!?! :shock:


not like us they don't :roll: :lol: :lol:
User avatar
jaybee
Regular
 
Posts: 512
Joined: Mon Nov 10, 2003 10:53 am
Location: Antwerp, Belgium

Postby ricochet » Fri Dec 22, 2006 6:18 pm

Those little suckers are always on the lookout for a shortcut.
User avatar
ricochet
Regular
 
Posts: 10256
Joined: Thu Jan 01, 1970 12:00 am
Location: Bristol, Tennessee, USA

easy schematic tips

Postby Splash » Sat Dec 23, 2006 8:11 pm

If you look at the input jacks in this schematic, you will see j1 (jack #1) goes thru R1 (resistor #1) and then it connects to the wire from J2 (input jack #2) that also goes thru a resistor r2. So, if you plug into J1 that signal can be picked off as it goes to the 1st stage of V1 (12AX7) of the preamp by plugging into J2. Follow the wires...

Image

PEACE
Scott
Believe in Magic!
User avatar
Splash
Regular
 
Posts: 23
Joined: Tue Dec 19, 2006 9:35 pm
Location: Fort Lauderdale, Florida

Previous

Return to Wish I'd Known This!!

Who is online

Users browsing this forum: No registered users and 1 guest