Fitting Plastic Finger Picks

Problems with equipment? Problem fitting them into the above forums? Post 'em here.

Fitting Plastic Finger Picks

Postby Bant's Bluz » Sun Apr 08, 2012 1:00 pm

This subject has been bandied about quiet a bit, but I was given some Dunlop tortise shell appearing finger picks. In thier present condition I can't use them. I've read about soaking the picks in hot water, then slipping them onto the fingers, but I can't remember if the water was supposed to be boiling or just what.
Pointers are appreciated.
Bant's Bluz
Regular
 
Posts: 408
Joined: Fri May 19, 2006 1:33 pm
Location: GA

Re: Fitting Plastic Finger Picks

Postby bottleneck » Sat Jun 30, 2012 9:06 pm

i do it with water below boilng,or with a hot hair dryer.

www.shakeylee.com
bottleneck
Regular
 
Posts: 488
Joined: Thu Jan 01, 1970 12:00 am
Location: PHILADELPHIA


Return to Equipment Blues

Who is online

Users browsing this forum: No registered users and 1 guest

cron