Page 1 of 1

Adding on a speaker cab?

PostPosted: Wed Feb 10, 2010 10:36 pm
by Buffalo_Bill
Hey Folks, I have a Peavey TNT-115-S combo amp, 150 watts into 4 ohms. It has no power amp output jack for adding external speakers.
I'm sure I can install a jack myself, but what would be the proper ohm rating for any speakers I connect? I would like to add a 2 x 8" speaker cab.
I notice that the new TNT 115 does have an external speaker jack, wired in parallel, and they recommend that it should be 4 ohms or greater.
Thanks.
Bill