Strict Standards: Non-static method phpbb_feed_factory::init() should not be called statically in /home/bigroadblues/bigroadblues.com/forum/feed.php on line 66
[phpBB Debug] PHP Notice: in file /feed.php on line 171: Cannot modify header information - headers already sent by (output started at /feed.php:66)
[phpBB Debug] PHP Notice: in file /feed.php on line 172: Cannot modify header information - headers already sent by (output started at /feed.php:66)
Big Road Blues Discussion Forums 2009-10-21T03:41:31+00:00 http://www.bigroadblues.com/forum/feed.php?f=7&t=10429 2009-10-21T03:41:31+00:00 http://www.bigroadblues.com/forum/viewtopic.php?t=10429&p=99769#p99769 <![CDATA[Re: Fuse Question]]> You are correct. The voltage won't matter as long as it's not rated lower. You wouldn't want to use a 12 volt fuse or breaker, for example. You do not want to substitute a higher amperage rated fuse as it will allow more current to flow before blowing thus risking damage to the equipment or even fire! I have seen folks replace blown fuses in their autos with a higher amp rated unit and the insulation melted off of the wires before the fuse blew!

ty

Statistics: Posted by thunda1216 — Wed Oct 21, 2009 3:41 am


]]>
2009-10-21T00:30:24+00:00 http://www.bigroadblues.com/forum/viewtopic.php?t=10429&p=99766#p99766 <![CDATA[Re: Fuse Question]]> not hold true of amperage, since the fuse's job is to fail when there is too much current. Either fuse should be ok.

Statistics: Posted by zhyla — Wed Oct 21, 2009 12:30 am


]]>
2009-10-20T18:11:26+00:00 http://www.bigroadblues.com/forum/viewtopic.php?t=10429&p=99756#p99756 <![CDATA[Fuse Question]]> The other night at a gig, my '83 Fender Concert blew a fuse. (Luckily, between sets). I usually carry a few extra fuses but that night I had forgotten. The Concert is a 60 watter and it takes a 2.5 amp, 125V Slo-Blo. That night the rhythm guitar player had a 2.5 amp, 250V Slo-Blo, so I used it. Can I continue to use the 250, or will it blow real soon? By leaving it in, will it damage the amp in any way? I'm picking up a few of my 125V fuses today and I'll pop it out and replace it, anyway. Any info?
Thanks.

Statistics: Posted by Bluesrocker — Tue Oct 20, 2009 6:11 pm


]]>